MAXQ3181 低功耗、有功功率测量、多相AFE (应用电

MAXQ3181 低功耗、有功功率测量、多相AFE (应用电路)

概述

The MAXQ3181 is a dedicated electricity measurement front-end that collects and calculates polyphase voltage, current, active power and energy, and many other metering parameters of a polyphase load. The computed results can be retrieved by an external master through the on-chip serial peripheral interface (SPI™) bus. This bus is also used by the external master to configure the operation of the MAXQ3181 and monitor the status of operations.

The MAXQ3181 performs voltage and current measurements using an integrated ADC that can measure up to seven external differential signal pairs. An eighth differential signal pair is used to measure the die temperature. An internal amplifier automatically adjusts the current channel gain to compensate for low-current channel-signal levels.

关键特性

Compatible with 3-Phase/3-Wire, 3-Phase/4-Wire, and Other 3-Phase Services

0.1% Active Power and Energy Linearity Error

0.5% Apparent Power and Energy Linearity Error

0.5% Linearity Errors for RMS Voltage and RMS Current

Neutral Line Current Measurement

Line Frequency (Hz)

Power Factors

Phase Sequence Indication

Phase Voltage Absence Detection

Programmable Pulse Width

Programmable No-Load Current Threshold

Programmable Meter Constant

Programmable Thresholds for Undervoltage and Overvoltage Detection

Programmable Threshold for Overcurrent Detection

Amp-Hours in Absence of Voltage Signals

On-Chip Digital Temperature Sensor

Precision Internal Voltage Reference 2.048V 30ppm/°C typical), Also Supports An External Voltage Reference

Active Power and Energy of Each Phase and Combined 3-Phase (kWh), Positive and Negative

Apparent Power and Energy of Each Phase and Combined 3-Phase

Supports Software Meter Calibration

Up to 3-Point Multipoint Calibration to Compensate for Transducer Nonlinearity

Power-Fail Detection

Bidirectional Reset Input/Output

SPI-Compatible Serial Interface with Interrupt Request (Acitve-Low IRQ) Output

Single 3.3V Supply, Low Power (35mW typical)

应用/使用

3相有功功率电表

典型应用电路

低功耗测量多相功率电路

免责声明：本网信息来自于互联网，目的在于传递更多信息，并不代表本网赞同其观点。其原创性以及文中陈述文字和内容未经本站证实，对本文以及其中全部或者部分内容、文字的真实性、完整性、及时性本站不作任何保证或承诺，并请自行核实相关内容。本站不承担此类作品侵权行为的直接责任及连带责任。如若本网有任何内容侵犯您的权益，请及时联系我们，本站将会在24小时内处理完毕。